Gingival Retraction Paste

Indications: 

ATYANTA Gingival Retraction Paste is a paste containing aluminium chloride, and is intended to be used for the temporary retraction and hemostasis of the gingival margin during dental procedures. These procedures include dental impressions, restorations, seating of temporary and permanent restorations, placement of rubber dam, and other procedures.

Composition:

25% Aluminium chloride, Additives and Gel forming agents.

Advantages:

· Promotes Moisture Control, Hemostasis and Gingival retraction.

· Quick Clean Up with a quick rinse and air dry to remove residue, ATYANTA Gingival Retraction Paste is as simple to clean up as it is to apply.

· Simple placement technique Designed to deliver quick and easy tissue displacement to enhance or replace a cord technique.

· Universally Compatible.

Directions to Use:

1. For better results, isolate the operative field.

2. Remove the cap from ATYANTA Gingival Retraction Paste and properly attach the needle tip.

3. Rinse the sulcus with water and air dry before application of the paste.

4. Gently insert needle tip of ATYANTA Gingival Retraction Paste into the sulcus and slowly inject paste into and around the gingival sulcus. Fill the sulcus so that an excess appears.

5. Leave the ATYANTA Gingival Retraction Paste place for a minimum of 2 minutes but no longer than 10 minutes for paste to control the fluids and create retraction. Keep moisture away from the treated site.

6. Remove the ATYANTA Gingival Retraction Paste completely from the sulcus using water and air with simultaneous use of dental suction.

7. Rinse thoroughly and dry the site prior to making the impression.

8. Take your impression, using any impression materials or digital imaging system.

Warning:

1. ATYANTA Gingival Retraction Paste should not be used on periodontally involved tissues, open furcations, or exposed bone.

2. ATYANTA Gingival Retraction Paste contains 15% aluminium chloride. Do not use on patients with known sensitivity to aluminium chloride.

3. Make sure that all remnants of ATYANTA Gingival Retraction Paste are removed before application of impression material. Aluminium chloride will interfere with the setting of polyether and polyvinyl siloxane impression materials. Remnants of the material may also distort digital imaging or contaminate restorative materials while restoring Class II or Class V preparations.

Usage Precautions:

1. Attach the needle to the capsule immediately prior to use. Leaving the needle attached to the capsule will cause hardening the paste inside the needle and it prevents proper delivery of the product.

2. Never use excessive force to extrude the paste since it may cause over dispensing of the material. If resistance is felt replace current tip with a new tip and check flow extra orally.

3. While dispensing the product into the sulcus make sure that the needle is not introduced too deep since an aggressive invasion of periodontal space or biological width may cause gingival recession.

4. Do not leave the material in the sulcus for longer time than it is needed to obtain retraction. Prolonged exposure time to the retraction paste may cause gingival tissue damage.

5. Do not leave ATYANTA Gingival Retraction Paste for longer than 10 minutes.

6. Needle tips are single use only to prevent cross-contamination between patients.

7. It’s important to remove the paste completely from the sulcus, as residue may inhibit set of impression materials or distort digital imaging.

Storage:

• Store product at ambient temperature. Avoid excess heat. Keep product in foil until use.

• Do not use after expiration date.

Disposal:

• For proper disposal follow National, State and Local Municipal Body laws.